MQ뒤에 붙은 숫자들에 따라 용도가 살짝 다르다.
우선 가스센서는 MQ-4라는걸 기억하고 나머지는 참고하면 좋을듯 싶다.
MQ-2 Smoke Gas LPG Butane Hydrogen Gas Sensor Detector Module
MQ-3 Alcohol Ethanol Sensor Breath Gas Detector Ethanol Detection
MQ-4 Methane Gas Sensor Natural Coal Co methane detector module
MQ-5 Methane Gas Sensor Shield methane detector module
MQ-6 LPG Gas Sensor Isobutane Propane Sensor
MQ-7 Carbon Monoxide CO Gas Sensor Module
MQ-8 Hydrogen Gas Sensor Module Gas Sensor module
MQ-9 Combustible Gas Sensor Detection Carbon Monoxide Alarm Module
MQ-135 Sensor Air Quality Sensor Hazardous Gas Detection Module
모듈 사용시 아래 그림의 PinOut을 참조하면 된다.
2번핀을 제외한 3개의 핀을 사용하며 3번핀이 Signal Pin에 해당한다.
모듈을 사용하지 않을경우 6개의 핀중 어떤걸 사용해야하는지 알면 된다.
헌데 BreadBoard에 꼽기에는 핀이 다소 두껍다.
두께를 정확히 말하긴 어렵지만 굳이 비유하자면 Jumper Cable에 딱 들어가는 사이즈이다.
https://www.pololu.com/product/1479
https://www.sparkfun.com/products/8891
http://www.theorycircuit.com/choose-gas-sensor/
(중략)
Basically every MQ sensors have one Heater inside with an electro-chemical sensor.
They are best to smell Gas in indoors at room temperature,
by connecting load resistor as variable one we can calibrate the sensor gas detection sensitivity more or less.
연결함으로써 부하저항을 as 변수로써 우리가 조절할수있는 가스감지 민감도를.
(중략)
Connect both A pins together & B pins together
and apply +Vcc supply to the coupled A or B pins
and apply GND through variable load resistor (RL) to the remaining coupled A or B pins.
Make sure that heater pins H & H connected with Vcc and GND.
A끼리 그리고 B끼리 묶는다.
'졸업작품 > 가스벨브+ 현관문 (bluetooth + Multi Servo)' 카테고리의 다른 글
가스감지 (ATmega128 + Servo + Fan) (8) | 2016.11.06 |
---|---|
HomeAutomation (6) | 2016.10.12 |